- Ingredients & Safety
Applications & Uses
Tell us your thoughts!
Be the first to submit a testimonial on Krud Kutter Rust Remover Gel.
Directions for use:
Remove any oil, grease, or dirt from the surface to be treated. On heavy rusted surfaces, remove any loose rust particles with a wire brush. Rinse the metal with water, to break the surface tension, and wash away any loose dirt. Turn sprayer to “SPRAY” position, and apply remover liberally to surface. Continue to apply the remover as needed, to keep the surface wet until the rust is dissolved. Disassemble units composed of moveable parts before applying remover. Clean parts and allow to dry before reassembling.
DISSOLVING RUST FROM IRON OR STEEL: Turn sprayer to “SPRAY” position, and apply remover liberally to surface. Continue to apply the remover as needed, to keep the surface wet until the rust is dissolved. Chemical action begins at once. Cleaning time will vary according to the severity of the rust. Medium to light rust will be dissolved in 10 minutes or less, while heavier deposits may require a second application. Once the rust is dissolved, rinse with water, and wipe the surface dry. After one hour or more, the surface is ready to be painted.
ALUMINUM/CHROME: Apply the remover to a wet surface. Allow time to dissolve the rust, then rinse away with clean water, and buff dry with a cloth.
GALVANIZED SURFACE: Where the surface is unbroken, treat as suggested for aluminum. Where rust is showing at the surface, treat as for iron or steel.
Caution: Contains phosphoric acid. SEVERE EYE AND SKIN IRRITANT. In case of contact with eyes or skin, flush with water for 15 minutes. If irritation persists, seek medical attention. If swallowed, take large amounts of water. Do not induce vomiting. Get medical attention. Material Safety Data Sheet available.
KEEP OUT OF REACH OF CHILDREN.
24-hour medical emergency: Chemtrec
Domestic North America 800-424-9300
International (collect calls accepted) 703-527-3887